RTG-64DVLN replaces RTG-64DVN

• 3/5” Concentric Vent System with Intergrated Condensate Collector
• Connects to Metal Fab Inc., 3/5” Concentric Venting without an adapter
• Vent Termination Kits are required for Direct Vent models 
• Next Generation Burner Technology
• Low Activation Flow Rate - Less than .45 GPM
• UMC-117 remote control and 10ft of thermostate wire is included
• EZ-Link cable available for high demand applications to connect two tankless units to operate as one
• Manifold up to 6 Units with an Optional MIC-6 manifold control board
• Exclusive! All Rheem models can be linked in up to 20 unit manifold installations by using the optional MIC-180 and MICS-180 manifold control assembly
• High-altitude capability-up to 9,840 ft. elevation above sea level (no chip required)
• Exclusive! Guardian OFW overheat film wrap
• All Rheem tankless models are third-party efficiency certified by GAMA
• Continuous hot water, energy saving and compact space saving design
• Intelligent electronic controls designed to increase energy efficiency and safety
• Self diagnostic program
• Digital display shows temperature setting and maintenance codes
• Built-in electric blower
• Uses Category III stainless steel vents and vent horizontally or vertically
• Supplied with a 120 volt power cord
• Environmentally friendly Low NOx burner meets SCAWMD rule 1146 requirements
• Freeze protection to -30 degrees F
• 11,000 - 150,000 BTU max
• Temp Range 100 - 140 degrees F
• 6.4 gal/min at 35 degree F rise max.
• 5.6 gal/min at 45 degree F rise